#prusawire #positron3d ## Step 1 - Clean Assembly - [x] Swap in Erik revised Y Idler - [x] Swap in Erik revised Y tensioner - [x] M3 x 16 SHCS - [x] Swap in revised X idler - [x] M3 x 35 SHCS - [x] Swap in revised Z idler - [x] M3 x 35 SHCS - [x] Swap in revised X motor mount - [x] Swap in revised Z motor mount - [x] y_belt_tensioner_rear is missing M3 Square Nut (1x) - [x] y_rod_holder_front_right is missing M3 Heatset Inserts (both 2x front and 4x back) - [x] y_rod_holder_front_right is missing M3x10 SHCS (1x) - [x] x_carriage_right is missing top M3 Hex Nut - [x] Top Panel is missing all 8x M3 3030 Roll in (or printed) T-Nuts ## Step 2 - Export BOM from Fusion ## Step 3 - Identify BOM Improvements - Verify that published BOM includes hardware (or not) for Stealthburner. - Potentials to investigate - ==Remove the M3 3030 T Nut from the BOM -- replace with printed part and heat set inserts!== - ==IMO this is fine for the PSU, but discuss with team.== - ==These are $0.79 each at KB-3D!== - Top panel uses 8x M3x10 BHCS. SHCS could totally be used and possibly eliminate this part. - Y Tensioner Front uses ??? BHCS + shim. SHCS + shim would probably be fine in practice and potentially eliminate need of this fastener. - Y Tensioner uses M3x12 SHCS in Beta 1. Erik's proposed R1 part uses M3x16 SHCS - M3x16 is already used for mounting rear part to Y carriage. - ==Where else is M3x12 SHCS used that we can possible eliminate?== - Raspberry Pi Mount could probably be tweaked to use M3 Heat Set Insert + M3x10 SHCS - Nighthawk-SB could probably be tweaked to use M3 Heat Set Insert + M3x10 SHCS - 5VDC Buck could probably be tweaked to use M3 Heat Set Insert + M3x10 SHCS